Installing a fully automatic vacuum packaging machine is actually not difficult, mainly involving three steps: unpacking and inspection, placement, and power connection. Let me break down the specific operations for you:
Unpacking and Inspection
Unpacking: Carefully open the packaging box and remove the main machine, power cord, foot switch (if applicable), and all accessories.
Inspection: Confirm that the machine is undamaged and check that the instruction manual, warranty card, etc., are complete.
Placement and Fixing
Location Selection: Place the machine on a stable, sturdy, level surface, leaving sufficient space for heat dissipation (10-20cm around the machine).
Fixing: Some models require securing with the included screws to prevent movement during operation.
Connecting Power and Accessories
Connecting Power: Plug the power cord into a socket with the matching voltage, ensuring proper grounding.
Connecting Foot Switch: If applicable, plug the switch into the designated interface on the machine.
Installing the Sealing Film Roll (Crucial!)
Loading the Roll: Mount the sealing film roll on the left/right bracket, and pull the film out from the inside.
Threading the Film: Guide the film through the tension tube and electronic eye, threading it out of the sealing area, ensuring the film is flat and wrinkle-free.
Securing: Adjust the position of the film roll to ensure smooth film pulling.
Power-On and Testing
Powering On: Turn on the power switch and set the sealing temperature (usually 150-180°C, refer to the instruction manual).
Preheating: Wait 5-10 minutes until the temperature stabilizes.
Testing: Test seal with a waste bag to check the sealing effect and adjust parameters (temperature, time).